EICR Testing & Inspection
North London

An EICR (Electrical Installation Condition Report) is a thorough check of every electrical circuit, socket, switch, and the consumer unit in a property — to confirm the wiring is safe and meets current British Standard (BS 7671). It's a multi-page document with test data and photos, not just a quick visual check.

What we test:

• Consumer unit, earthing, and main bonding
• Every circuit (lighting, sockets, dedicated)
• RCD protection and trip times
• Insulation resistance and earth-loop impedance on every circuit
• A sample of accessories (sockets, switches, light fittings)
• Cable conditions where accessible

What an EICR does not cover: appliances (those need PAT testing) and smoke/heat alarms (separate test, but we can do both at the same visit).

Our North London pricing:

• Standard EICR (most 1-3 bed flats and houses): £180
• Landlord pack / 4+ bed or HMO (full report, fast turnaround, council-ready): £230

Why other quotes vary so wildly: a proper EICR takes 3-4 hours on a 3-bed property. Anyone offering £49 or £75 EICRs is doing a cursory visual check — they don't open sockets, don't measure insulation resistance on every circuit, don't pressure-test the earth. The report they hand you may say "satisfactory" while real C2 failures hide. Worse, it's worthless if your council asks for the test data — there isn't any.

What's included in our price: full inspection, written report with every observation coded, all measured test data, photos where helpful, and Clear EICR Report turnaround.

For a typical 3-bed North London property, allow 3-4 hours. Smaller flats are 2-2.5 hours; HMOs and 4+ bed properties take 4-5+ hours.

What happens during the visit:

• We'll need access to every room with electrics
• Each circuit is dead-tested (power off briefly per circuit, 5-15 minutes each)
• Sockets and switches are sampled and opened to check terminations
• The consumer unit is opened and inspected
• We test earthing, main bonding, and RCD operation
• We may need to access the loft and the meter cupboard

Power isolation: only OFF for short stretches per circuit while testing. The fridge stays on, the Wi-Fi router stays up. We give you a heads-up before each isolation so nothing important gets affected.

What you need to do: nothing special. Clear access to the consumer unit, leave us a key, and we'll lock up after.

The legal requirement only bites on rented property. Quick segment guide:

• Landlord (private rented): Legally required at least every 5 years, or sooner if the previous report specifies. A valid existing report can usually be passed to a new tenant without a fresh inspection. Enforced by your local authority (councils across north London are active on this in the core boroughs).
• Owner-occupier (you live there): Not legally required. Recommended every 10 years or after any major electrical change.
• Buyer (pre-purchase): Not required by law, but increasingly requested by mortgage lenders and solicitors. Strong negotiation tool if it fails.
• Seller: Not legally required, but solicitors and buyer surveys increasingly ask for one. A clean EICR speeds up sales.

North London has a particularly high concentration of HMOs and landlord-let stock — local councils have been active with EICR enforcement, with civil penalties issued for non-compliance.

Don't panic — "unsatisfactory" is a technical word, not a fire alarm. It means at least one C1, C2, or FI code was found, but those letters mean very different things:

• C1 — Danger present: Real, immediate danger (exposed live conductors, missing earth on a gas-bonded pipe). We isolate the circuit on the spot. Rare in modern wiring, more common in pre-1960s installations.
• C2 — Potentially dangerous: Could become dangerous (missing RCD on a bathroom circuit, accessible bare cable in a loft, undersized earth). Must be fixed within 28 days for landlords. Most common reason an EICR fails in North London.
• C3 — Improvement recommended: Doesn't meet current regs but isn't dangerous (e.g., plastic consumer unit where modern is metal). C3 alone does NOT fail an EICR.
• FI — Further investigation: Inspector spotted something they couldn't fully test on the day. Needs a follow-up visit, not a fail.

A report with only C3 and no other codes is satisfactory. Many "failed" EICRs are just one C2 — usually a missing RCD that's a £180-£300 fix, not a rewire.

The clock starts the day you receive the unsatisfactory report.

In order:

1. Within 28 days — complete all C1, C2, and FI remedial work (or sooner if the report specifies — sometimes 7 or 14 days for genuine hazards)
2. Within 28 days of the work completing — get written confirmation from a qualified electrician that the remedial work is done (we issue this as part of the remedial visit)
3. Within 28 days of the work completing — provide that confirmation + the original EICR + the remedial certificate to your tenant
4. On request — provide the same documents to your local authority

What happens if you don't comply: civil penalties up to £30,000, possible HMO licence consequences, and the council can arrange the work themselves and recover costs from you. Local councils do enforce — North London landlords (particularly N9-N22, EN1-EN4 and E4 HMO operators) have been hit. Don't ignore the report.

Almost never. In our experience across North London properties, around 90% of failed EICRs are fixed with targeted remedial work, not a rewire. The most common fixes:

• No RCD protection on circuits → consumer unit upgrade (£800-£1,200, often fixes the whole report)
• Missing main bonding to incoming gas/water → 1-day remedial job (£200-£400)
• Damaged sockets or switches → replace just the damaged accessories (£20-£50 per item)
• Borrowed neutrals in lighting circuits → targeted lighting circuit rewire (£300-£600)
• Burned or damaged cable section → replace that section only (£200-£500)

A full rewire is only justified when:

• Most circuits are running pre-1970s rubber or cloth-covered cables (common on Edmonton, Wood Green, and Palmers Green period properties)
• The report flags multiple C1/C2 codes across the majority of circuits

Send us the failed report and we'll give you a straight read: targeted remedial, partial rewire, or full rewire — and the actual price for each option.

Yes, almost always. An EICR before exchange (£180) is one of the cheapest insurance policies in the buying process.

Why it's worth it:

• Mortgage lender comfort — some lenders ask, others appreciate a clean report
• Solicitor sign-off — buyer's solicitor's electrical-related comments get resolved without back-and-forth
• Real evidence to negotiate — if the report shows C1 or C2 codes, you can drop your offer by the cost of remedial work (typically £1,500-£8,000)
• Peace of mind — avoids buying into hidden electrical problems

Best practice: book the EICR after the homebuyer's survey comes back, before exchange. Booking-to-report turnaround is usually 2-3 days. We'll send the EICR directly to you (and your solicitor if you want).

Trap to avoid: don't accept a "vendor's EICR" that's more than 12 months old, or one done by an electrician you can't verify. Pay the £180, get your own.

Not legally required, but increasingly worth the £180-£230.

Why sellers are getting one before listing:

• Solicitors are asking — slows or even kills sales when there isn't one
• Buyer surveys routinely ask "is there a current electrical certificate?" — having one removes that objection upfront
• Lenders are starting to ask
• You catch problems early — if it comes back unsatisfactory, you've got time to fix it (or price it in) before a buyer's solicitor finds it for you

When you don't need to bother: if you've just done a full rewire (the EIC from the install covers it), or you're selling at auction.

If your North London home is 10+ years from its last electrical work, an EICR before listing is usually the smarter move. We can usually fit a survey within a few days.

Depends on who you are and the property:

• Landlord (rental property): Every 5 years, or sooner if the previous report specifies. A valid existing report can usually be passed to a new tenant without a fresh inspection. (UK Electrical Safety Standards 2020.)
• HMO landlord: Same 5-year rule, but your local council may ask annually as part of HMO licensing — check your specific licence.
• Owner-occupier (you live there): Every 10 years recommended, or sooner after any major electrical work.
• After major works: After an extension, kitchen rewire, or any significant electrical change — even if you got an EIC for the new work, an EICR confirms the rest of the system is still safe.
• Commercial property: Every 5 years, or 1-3 years for high-risk environments.

If you're not sure when the last EICR was, check your house papers. We can also check the consumer unit for an EIC sticker dated by the last electrician.

Yes — and it's smarter than skipping it.

Common scenarios where an EICR catches things:

• After an extension or kitchen renovation: The new circuits get an EIC (Electrical Installation Certificate), but that only covers what was newly installed. An EICR confirms the rest of the house wasn't disturbed or compromised by the building work.
• After DIY electrical work: Anything beyond a like-for-like switch swap is technically Part P notifiable. If you (or a previous owner) added sockets, wired in a hob, or rewired a room without certification, an EICR finds what's safe and what isn't.
• Before letting (if you've previously been an owner-occupier): Required before the first tenancy — and you want to know what's there before tenants move in.
• Before insurance claims: Some insurers want a current EICR before paying out on electrical-fire claims.

Common discoveries we make on these inspections in North London: borrowed neutrals from DIY, undersized cables on extension circuits, unbonded gas pipes after kitchen replacements. Cheap to fix when caught early; expensive once they cause a fault.

The EICR pack we send is a full PDF containing:

• The report front page — your details, the property, electrician qualification, "satisfactory" or "unsatisfactory" verdict
• All observations coded C1, C2, C3, or FI — with the location and reason
• Test data — insulation resistance, earth-loop impedance, RCD trip times, on every circuit
• Photos where they help explain a finding (damaged cable, missing RCD, etc.)
• Recommendations — what's needed to bring an unsatisfactory report up to satisfactory

What you forward to whom:

• Tenants — full EICR within 28 days (plus any subsequent remedial certificates)
• Local authority (your council) — same documents on request
• Buyer's solicitor — full EICR if requested during conveyancing
• Mortgage lender — some ask for a current EICR before completion

We keep originals on file indefinitely. If you lose your copy, we re-issue free.